Welcome, Guest
Username Password: Remember me
  • Page:
  • 1

TOPIC: "Extend edit" function

"Extend edit" function 6 days, 13 hours ago #184452

  • jwrl
  • Moderator
    Pro User
  • OFFLINE
  • Moderator
  • Posts: 9424
  • 6 days, 13 hours ago
It would be really helpful to have an extend edit function in Lightworks. At the moment my workaround is (and always has been) to place a cut where I want to extend the edit to, open the edit that I want to extend in trim mode, then jump left or right depending on which side of the edit the cut is. Of course the cut could also be a mark - the principle is the same.

However how much simpler would it be to just use a single key? I have two macros that do it within certain constraints, but it would be much better if it was just part of the Lightworks toolset.
Last Edit: 6 days, 12 hours ago by jwrl.
  • Page:
  • 1
Time to create page: 0.33 seconds
Scroll To Top