Welcome, Guest
Username Password: Remember me
  • Page:
  • 1

TOPIC: Closing the "Machine Room" panel

Closing the "Machine Room" panel 2 years, 4 months ago #17830

  • kaif
  • OFFLINE
  • Fresh Boarder
  • Posts: 14
Hi there,

I opened up the "machine room" panel with the shortcut hold 'm' tap 'r'. Unfortunately I can't seem to find a way to close the panel. I tried repeating the command but just generated another panel which are now sitting in the corner of my room which is slightly distracting.

Forgive me if this is obvious but I can't seem to find an answer on the forum about it.

Thanks in advance!
( -.-).o0O(kaif.me)

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17831

You'll need to use the shark
Lightworks development

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17832

  • kaif
  • OFFLINE
  • Fresh Boarder
  • Posts: 14
Hmm, tried left and right clicking the shark but it doesn't seem to do anything. Not quite sure what you mean by using the shark (sorry if it's obvious but I'm just starting out so not quite familiar with the lingo yet). Thanks, much appreciated.
( -.-).o0O(kaif.me)

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17833

Not quite sure what you mean by using the shark

No problem - pick up the shark with the right mouse button, move it over the unwanted panel, then click the left button (whilst still holding the right).
Lightworks development

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17834

  • kaif
  • OFFLINE
  • Fresh Boarder
  • Posts: 14
Hammerhead wrote:
Not quite sure what you mean by using the shark

No problem - pick up the shark with the right mouse button, move it over the unwanted panel, then click the left button (whilst still holding the right).


Ah great, that worked. Thanks mate!
( -.-).o0O(kaif.me)

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17835

  • DJFJEKETE
  • Pro User
  • OFFLINE
  • Expert Boarder
  • Posts: 111
Why does the shark take so long to go back to the corner? I don't know about everyone else but it always takes like a minute or two to return back to the corner. I usually take a water break while its going back to the corner. And the name of the shark is Lucy right? I like Lucy she keeps my work space clean!

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17837

Why does the shark take so long to go back to the corner?

Left-clicking an empty shark increases the rate at which it swims
Lightworks development

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17842

  • jwrl
  • Pro User
  • OFFLINE
  • Moderator
  • Posts: 1376
DJFJEKETE wrote:
I usually take a water break while its going back to the corner.

You don't need to. Just keep working - she'll look after herself and find her own way home.

Re: Closing the "Machine Room" panel 2 years, 4 months ago #17848

  • DJFJEKETE
  • Pro User
  • OFFLINE
  • Expert Boarder
  • Posts: 111
Yea i know she'll go back to where she is supposed to be, but sometimes i just take a break cause after sitting down for long periods of time i just wanna take a break and walk to get a drink of water
  • Page:
  • 1
Time to create page: 1.18 seconds